For Sale Amari T30 Turntable and Tonearm Package

Further Information

AMARI T30  (NOW HANSS T30)bought fron Audio Engineer last year, he made a few mods to improve .also made special tonearm mounting for wand tonearm

 The T-30's feet used opposed magnets to provide an isolating spring action. Similarly, the 2.73"-thick, heavy, black-anodized aluminum platter is supported by an appropriately robust bearing, using magnetic opposition to relieve some but not all of the contact pressure between parts. The bearing's rare-earth magnet probably could do the whole job, but Levy says that a properly adjusted T-30 bearing allows contact between the ceramic lower spindle, stainless-steel thrust ball, and brass bearing well/thrust pad, to achieve the proper degree of mechanical grounding. The inner surface of the height-adjustable bearing well is machined with a spiral groove, presumably to help circulate the relatively light oil within.

Hanss supplies two AC synchronous motors with the T-30, each topped with an acrylic drive pulley and snugged into a multi-tiered aluminum base that's intended to not touch the plinth. The two bases look identical but are of slightly different heights; thus, the three silicone-rubber drive belts powered by the left-hand motor ride the platter a bit higher than the three belts powered by the right-hand motor, for even drive distribution. AC cords from both motors plug into the back of a common outboard power supply, nicely styled to complement the T-30's plinth. In addition to producing clean, stable sinewaves for the motors, the power supply provides a central On/Off switch for both, plus fine-tuning of the selected speed (33.3 or 45rpm, but no 78).
: the Hanss T-30, which offers the buyer two tonearm mounts, two motors, a massive platter, magnetic isolation, exotic styling, and an inarguably fine level of manufacturing quality, all for $8000. Yes, that's wildly more money than most people would consider spending on a record player; and, yes, that's good value.
Description: Two-speed belt-drive turntable with 2 AC synchronous motors, 2 tonearm mounts,(REGA left side.)   outboard power supply. Speeds: 33.3rpm, 45rpm. Wow, flutter, rumble: unspecified.
Dimensions: 24.8" (635mm) W by 8.7" (222mm) H by 17" (435mm) D. Weight: 83.2 lbs (37.8kg).
12 inch plus The Wand tonearm. Superb tonearm built in NZ .
This is a newer build. so it has the brand new tonearm lift.  Retail $2600aud.
Has manual, metal setup tool , wooden presentation box, tonearm all instructions alignment jig
Denon moving coil cartridge fitted.

TOTAL RETAIL  S12000 !!