For Sale Krix Dynamix mk1 Surround Speakers

Further Information

Krix dynamix mk1 on wall surround speaker. It's black vinyl wrapped. It's been used as part of a 7.2 surround setup. It's been drilled into the back with a bracket to fit on the wall and better angle it in. So they do have holes in the back. I contacted Krix about doing this and the crossovers aren't in that area where I drilled into. There's also some marks on the metal bracket holes for hanging. Pictures are attached for these.

Happy to include these brackets for nothing also which I got from selby acoustics. 

I've had this pair for quite a few years as it's the original mk1. It differs from the current mk4 with a different driver and tweeter. The speaker terminals are at the top of the cabinet too. The mk4s are on the rear of the cabinet.  

Inspection welcome and if you can be bothered driving to Gippsland I can hook these up and you can audition. I do go to Melbourne often too. So I could even drop them off possibly.

I do have the original box but I'm ideally looking not to post these.

Specs:

Frequency Range: 45Hz – 20kHz in room response.

Power Handling: Maximum 100 watts RMS amplifier power.

Sensitivity: 88dB for 2.83 Volts at 1 metre.

Configuration: 5 inch 2-way.

Bass Driver: 5” doped paper curvilinear cone with cast aluminium basket, 1” voice coil wound on high powered aluminium former, with copper shorting ring, and vented double magnet shield.

Tweeter: High quality 1” doped fabric dome, Ferro fluid cooled with double magnet shield.

Crossover Point: 1.8kHz.

Impedance: Nominally 6 Ohms.

Enclosure Type: Bass reflex, front vented.

Weight: 6kg each