Armitage Posted November 17, 2017 Posted November 17, 2017 Hi there, New to the forum. I have recently somehow managed to break a USB port (type B ) by plugging in a USB cable. I just wanted to ask if anyone knows whether it would be possible to replace the port, and how I would go about doing this. The reason I want to go for this route is it's a fairly new piece of equipment and I'd rather not buy a new one outright. Also I'm not very handy with complex electronics so are there any electronics people in Melb who would be able do this for a fee? Any advice would be appreciated, Thanks.
Gordon Macfarlane Posted November 17, 2017 Posted November 17, 2017 It should be possible to replace the port but it will require the pcb to be removed so the faulty socket can be desoldered , replaced and resoldered. Best left to a tech if you don't have the right tools or experience but I would be very surprised if it couldn't be fixed. Some of the guys in Melbourne will chime in with a list of good techs ,I am sure. 2
Guest Muon N' Posted November 17, 2017 Posted November 17, 2017 As long as It hasn't caused a short and damaged anything else it should be a straight forward job for a competent tech'.
Armitage Posted November 19, 2017 Author Posted November 19, 2017 Maybe I should post this in the Computers & Technology forum? I was really hoping not to buy a whole new device but looks like I might have to if I can't get it fixed.
rockeater Posted November 20, 2017 Posted November 20, 2017 I have done this recently for a SNA member in Perth. Take covers off and take it to Altronics/Jaycar/WES to get a spare. Then assess if you can do it yourself or not. If you were in Perth, I would have done it for you for a six pack of Pale Ale. Cheers Roman
Armitage Posted November 20, 2017 Author Posted November 20, 2017 (edited) @rockeater That would have been perfect! I would have gladly donated a whole case of Pale Ale I've taken a picture of the inside, I suspect I need to solder it off? It's the one with "MCH" on it. Unfortunately I have neither the right tools or skills to do the job. Edited November 20, 2017 by Armitage
Weka Posted November 20, 2017 Posted November 20, 2017 The solution has already been provided by @Ozcall ... take it to a reputable service tech!
Martykt Posted November 20, 2017 Posted November 20, 2017 Shouldn't be too much of an issue to wield a soldering iron for you @Armitage and am in Melbourne. The part is readily available so as long as nothing has shorted like @Noum suggested (then it might need a new board) I should be able to help you.
Armitage Posted November 20, 2017 Author Posted November 20, 2017 1 hour ago, Martykt said: Shouldn't be too much of an issue to wield a soldering iron for you @Armitage and am in Melbourne. The part is readily available so as long as nothing has shorted like @Noum suggested (then it might need a new board) I should be able to help you. Brilliant! PM sent. 1
Recommended Posts