john.reekie Posted October 12, 2023 Posted October 12, 2023 (edited) Further Information: I've been on a bit of an ergonomic keyboard quest the last few years and need to trim down. This is a Cherry Corne (v2) in an acrylic case (top and bottom), which was built by me from a kit from splitkb.com. It is fully functioning and has the Via firmware loaded so that you can program the key layout (and the lighting!) with Via, see screenshots. The controllers are Pro Micro and are soldered on (not socketed). It has "hot swap" sockets so you can change the switches out if you want to. Note that because the plate is 3mm acrylic the switches will tend to come out when you remove the keycaps anyway. The included switches are a brand new set of Akko CS crystal blue, which are a fairly light linear. FWIW I think they sound quite nice, not too loud and even on both down and up stroke. The translucent keycaps and the TRRS cable shown are also included. It's in excellent condition as it has only been used for a few hours testing. Just let me know if you have any questions Edited October 12, 2023 by john.reekie 1
Recommended Posts